TASK
Configure OSPF area 0 on R1, R2, R3, R4, and R5’s connection to the DMVPN
network:
Use process ID of 1 Advertise Loopback0 prefixes into area 0
Configure OSPF using process ID of 6 on R6, R7 and R9 as follows:
Advertise Loopback0 prefixes of R6 in area 67 and Loopback0 of R9 in area 79.
On R6, enable OSPF only for interfaces with the exact IP addresses of 150.1.6.6 and 155.1.67.6.
On R7, enable OSPF on all interfaces that are connect to another router
On R5 make a lookback interface with ip 8.8.8.8 also advertise a default route in OSPF and this need to be as an external Type 2 in the routing table. Then all the router need to be able to ping 8.8.8.8 all the routers use the default ospf values
a little warning. there was allready a network engineer done some OSPF config but he was laid off. rename the routers hostname to Rx.ospf.lab1 where X is the router ID
@admin load ospf1 config